Vehicle Make And Model Selection Window - SICE A98 Manuel D'instructions

To confirm the data entered and exit this window, proceed as follows:
- press the F3 key; you will be prompted to confirm saving of the data.
- press F3 to confirm,
If you do not wish to confirm saving, press F2.
When entering a new item, the system prompts the user with data for a similar vehicle to
simplify the entry of the tolerance data.
Notes
The data for a new customer and/or a new vehicle can also be entered at the end of the
measurement and adjustment procedure of a model chosen from the vehicle databank.
In the printing window, a message prompting the input of data will appear when saving of data
on request or in automatic mode has been set in the set-up. In the printing window, the data
input window is accessed by pressing the F9 key.

VEHICLE MAKE AND MODEL SELECTION WINDOW

If display of the vehicle make and model selection window has been set as part of the operating
sequence in the machine set-up, this window appears automatically.
It allows the user to select the make of the vehicle using the procedures described in the
"General Considerations" section.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F3 (or "Enter"): confirms selection of a make and advances to model selection window
- F4 chooses whether to display:
Makes/models file

• all the available makes;
• only makes from the primary databank;
• only user-defined makes in the secondary (personalised) databank.
Markets

• Argentina
• Brazil
• China
• Europe
• ............
Listing order

• Alphabetical
• By date
Vehicle description

• Commercial
• Manufacturer
- F6 modifies a previously entered make (only for user-entered makes)
- F7 deletes a previously entered make (only for user-entered makes if there are no
associated models).
- F8 enters a new make (see paragraph "Enter/Modify window")
- F10 returns to the starting window.
Notes
• The aligner cannot be operated unless a hardware protection key (SIM) has been inserted.
• The main protection circuit board configured for the basic version is supplied with the machine.
28