Switching The Aligner On And Off; Measuring Unit; General Considerations; Selecting Functions - SICE A98 Manuel D'instructions

For rims made of steel or with projecting edges, the clamps should be secured from the inside
(1, fig. 6); in the case of alloy rims secure the clamps from the outside (2, fig. 6), for rims with
plastic covers secure the clamps from the inside with the pins reversed (3, fig. 6).
If necessary, you can tap the wheel clamps gently with the hand to fit the clamp nose between
the rim and the tyre bead.
For other types of support clamps with a jaw or dedicated closing device, follow the instructions
attached and inserted in the specific package.
Mount the "vertical" targets on the front wheels and the "horizontal" targets on the rear
wheels.
Press the power button on the PC to activate the aligner.
Then wait until the starting screen is displayed (fig. 7).
To correctly switch off the aligner:
- go back to the starting screen (fig. 7)
- press the "F10" key;
- confirm by selectingthe symbol "√" ;
- wait until the computer is off (black screen).
Never switch off the machine when there is a page other than the logo page because
such an action might damage the PC.
If this should occur, when the PC is switched back on, the software will request the user
to press any key to perform the "SCANDISK" operation.
This operation is used to check that the PC has not been damaged and, if necessary, to
update some files that might have been damaged.
At the end of the process, if the program reboots normally, then no problems have
occurred. Instead, if any message appears that blocks the program start-up procedure,
contact the nearest technical assistance centre.
The equipment simple interface makes operation quick and easy to learn. The operating
procedures are generally standardised throughout the program, as summarised below.
The functions available in each program context are shown as special icons on a bar at the
bottom of the screen.
To select a specific function, press the key (from F1 to F10) indicated on the icon in question.
To facilitate and simplify the use of the machine, each key is generally associated with the same
type of command in the various program contexts.
In particular:
- F1 displays the on-line "Help".
- F2 equivalent to "Esc", goes back the previous window (except in the starting screen
where a password must be entered to shut down the program and switch control to
Windows

SWITCHING THE ALIGNER ON AND OFF

GENERAL CONSIDERATIONS

Selecting functions

®
).

Measuring unit

ATTENTION
17