Compensation" (Roc) Window - SICE A98 Manuel D'instructions

For the wheel aligner to operate, the main card must always be present and fitted into the
slot inside the unit; in case of malfunction, make sure that the reader is wired correctly
as described in the User manual.
• At start up, the program checks for the sim card and operating levels enabled. If the sim card
is not detected, an error message is displayed (fig. 24).
The program can be used only in demo mode.
Used to select and execute the procedure to compensate for the rim out-of-centre and out-of-
plane following the mode set by the selected method (figures 9-10-11 ).
The following ROC options are available:
• Push-mode ROC
• ROC skip
• ROC Recall
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F3 starts the selected ROC procedure (to move on to the next screen if the ROC Skip or
ROC Recallprocedure has been selected)
- F4 sets up the desired type of default compensation procedure and selects the vehicle
weight unit of measurement:
 Roc
Roc

• "Push-mode ROC ( 30° movement)
• "ROC Skip"
• "ROC Recall"
 unit of measurement:
Weight

• Kilograms
• Pounds.
- F5 used to scroll downward through the list of ROC options available
- F6 used to scroll upward through the list of ROC options available
- F10 used to go back to the starting screen.
Push-mode ROC
Select the icon
Fit the 4 targets to activate the procedure.
1) Place the vehicle on the lift on over the pit with front wheels straight and lock the steering
wheel with the steering lock.
2) Fit the targets on the wheels but do not lock the brake.
3) Follow the on-screen instructions.
4) Move the vehicle backwards so that the wheels complete a 30° rotation.
5) Move the vehicle forwards back to the initial position.

"COMPENSATION" (ROC) WINDOW

.
ATTENTION
29