Safety Regulations - SICE A98 Manuel D'instructions

Failure to observe these instructions and the relative danger warnings can cause serious
injury to operators and other persons present.
Do not power up the machine before you have read and understood all the
danger/warning notices in this manual.
This machine must be used only by qualified and authorised personnel.
A qualified operator is considered to be a person who has read and understood the
manufacturer's instructions, is suitably trained, and is confident with safety and adjustment
procedures to be adhered to during operations.
Operators are expressly forbidden from using the machine under the influence of alcohol or
drugs capable of affecting physical and mental capacity.
The operator must:
• Read and understand all instructions on how to use the machine.
• Make sure to have a thorough knowledge of the capabilities and features of this machine.
• Keep unauthorised persons well clear of the area of operation.
• Make sure that the machine has been installed in compliance with established legislation and
standards.
• Make sure that all machine operators are suitably trained, that they are capable of using the
machine correctly and that they are adequately supervised during their work.
• Do not touch power lines or the inside of electric motors or other electrical equipment until the
power has been disconnected and locked out.
• Read this manual carefully and learn how to use the machine correctly and safely.
• Always keep this user manual in a place where it can be readily consulted when working with
the machine and consult it whenever you are in need of confirmation or explanations.
Do not remove or deface the safety Danger, Warning or Instruction decals. Replace any
missing or illegible Danger, Warning or Instruction decal. Missing or damaged decals can
be obtained from your nearest dealer.
• When using the machine and carrying out maintenance on it, observe the standardised
industrial accident prevention regulations for high voltage industrial equipment.
• Any unauthorised alterations made to the machine automatically release the manufacturer
from any liability in the case of damage or accidents in relation with such alterations.
Specifically, tampering with or removing the machine safety devices is a breach of the
regulations for industrial accident prevention.
Infrared Radiation!
Do not get at close range or exposed too long to infrared radiation.
Do not observe directly with optical instruments.

SAFETY REGULATIONS

WARNING
WARNING
WARNING
12