Code Table - Lenze Global Drive 8200 vector Instructions De Montage

8.6

Code table

Tip!
•
The following table describes in detail the codes mentioned in the examples for
commissioning!
•
Do not change codes, the meaning of which is unknown to you! All codes are described in
detail in the System Manual.
How to read the code table
Column Abbreviation
Code Cxxxx
1
2
Cxxxx*
Cxxxx

Cxxxx

(A)
USEr
Name
Lenze
Choice 1
IMPORTANT -
Code Possible settings
No. Name Lenze
C0002*
Parameter set
 management
uSEr
Restorage of default
setting
C0002* Parameter set
transfer using the

keypad
uSEr
(cont.)
L
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Code Cxxxx
Subcode 1 of Cxxxx
Subcode 2 of Cxxxx
Parameter value of the code is the same in all parameter sets
Changed parameters will be accepted after pressing
Changed parameters will be accepted after pressing
Code, subcode or selection are only available when using an application-I/O
With Lenze setting the code is available in the menu
switching.
Name of the code
Lenze setting (default setting/value set under C0002)
Further information can be obtained from "IMPORTANT"
{%} 99 Min. value {unit}
Brief, important explanations
Selection
0 0 Ready
1 Lenze setting
2 Lenze setting
3 Lenze setting
4 Lenze setting
31 Lenze setting
61 Lenze setting
62 Lenze setting
63 Lenze setting
64 Lenze setting
Keypad Controller
70 With function module Application-I/O, INTERBUS,
PROFIBUS-DP, LECOM-B, DeviceNet/CANopen
10 With all other function modules
EDK82EV903 DE/EN/FR 2.2
Commissioning
Meaning
•
The parameter value of a code can be different in every parameter
set.
•
Parameter value accepted immediately (ONLINE)

 if the controller is inhibited
USEr
Max. value
PAR1
PAR2
PAR3
PAR4
FPAR1
PAR1 + FPAR1
PAR2 + FPAR1
PAR3 + FPAR1
PAR4 + FPAR1
Code table
. The menu USEr is active after every mains
IMPORTANT
PAR1 ... PAR4:
•
Parameter sets of the controller
•
PAR1 ... PAR4 also contain parameters for
Standard-I/O, Application-I/O, AS interface or
system bus (CAN)
FPAR1:
•
Module-specific parameter set of the
fieldbus function modules INTERBUS,
PROFIBUS-DP, LECOM-B,
DeviceNet/CANopen
•
FPAR1 is saved in the function module
Restorage of default setting in the selected
parameter set
Restorage of default setting in the fieldbus
function module
Restorage of default setting in the selected
parameter set of the controller and the fieldbus
function module
Use the keypad to transfer parameter sets to
other controllers.
During transfer the parameters cannot be
accessed via other channels!
All available parameter sets (PAR1 ... PAR4, and
FPAR1) are overwritten with the corresponding
keypad data
101