Lenze Global Drive 8200 vector Instructions De Montage page 103

Commissioning
Code table
Code Possible settings
No. Name Lenze
C0002* Parameter set
transfer using the

keypad
uSEr
(cont.)
C0002* Saving of own
settings

uSEr
(cont.)
C0002* Loading/copying of
your own basic

settings
uSEr
(cont.)
C0003* Non-volatile
parameter saving

102
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Selection
Keypad PAR1 (+ FPAR1)
71 With function module Application-I/O, INTERBUS,
PROFIBUS-DP, LECOM-B, DeviceNet/CANopen
11 With all other function modules
Keypad PAR2 (+ FPAR1)
72 With function module Application-I/O, INTERBUS,
PROFIBUS-DP, LECOM-B, DeviceNet/CANopen
12 With all other function modules
Keypad PAR3 (+ FPAR1)
73 With function module Application-I/O, INTERBUS,
PROFIBUS-DP, LECOM-B, DeviceNet/CANopen
13 With all other function modules
Keypad PAR4 (+ FPAR1)
74 With function module Application-I/O, INTERBUS,
PROFIBUS-DP, LECOM-B, DeviceNet/CANopen
14 With all other function modules
Controller Keypad
80 With function module Application-I/O, INTERBUS,
PROFIBUS-DP, LECOM-B, DeviceNet/CANopen
20 With all other function modules
Keypad Function module
40 Only with function module INTERBUS, PROFIBUS-DP,
LECOM-B, DeviceNet/CANopen
Function module
50 Only with function module INTERBUS, PROFIBUS-DP,
LECOM-B, DeviceNet/CANopen
9 PAR1 Own settings
5 Own settings PAR1
6 Own settings PAR2
7 Own settings PAR3
8 Own settings PAR4
1 0 Parameter not saved in EEPROM
1 Parameter always saved in EEPROM
3 Own settings saved in EEPROM
EDK82EV903 DE/EN/FR 2.2
IMPORTANT
Overwrite selected parameter set and, if
necessary, FPAR1 with the corresponding
keypad data
All available parameter sets (PAR1 ... PAR4, and
FPAR1) are copied to the keypad
Overwrite the module-specific parameter set
FPAR1 only
Copy the module-specific parameter set FPAR1
Keypad
only
You can save your own basic settings for a
controller (e.g. machine delivery status):
1. Ensure that parameter set 1 is active
2. Controller inhibit
3. Set C0003 = 3, acknowledge with
4. Set C0002 = 9, acknowledge with
5. Set C0003 = 1, acknowledge with
6. Enable the controller.
Using this function, PAR1 can be copied to
parameter sets PAR2 ... PAR4
Restorage of own basic setting in the selected
parameter set
Data loss after mains disconnection
•
•
Subsequently save parameter set 1 as own
basic setting with C0002 = 9


save your own basic settings

Active after every mains connection
Cyclic parameter changes via bus module
are not allowed.
L
, to