Lenze Global Drive 8200 vector Instructions De Montage page 107

Commissioning
Code table
Code Possible settings
No. Name Lenze
C0517* User menu

1 Memory 1
2 Memory 2
3 Memory 3
4 Memory 4
5 Memory 5
6 Memory 6
7 Memory 7
8 Memory 8
9 Memory 9
10 Memory 10
106
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Selection
50 C0050 Output frequency (MCTRL1-NOUT)
34 C0034 Analog setpoint selection range
7 C0007 Fixed configuration - digital input signals
10 C0010 Minimum output frequency
11 C0011 Maximum output frequency
12 C0012 Acceleration time main setpoint
13 C0013 Deceleration time main setpoint
15 C0015 V/f rated frequency
16 C0016 U boost
min
2 C0002 Parameter set transfer
EDK82EV903 DE/EN/FR 2.2
IMPORTANT
•
After mains switching or when using the

function the code from C0517/1 will be
displayed.
•
In Lenze setting, the user menu contains the
most important codes for starting-up the
control mode "V/f characteristic control with
linear characteristic"
•
When the password protection is activated,
only the codes entered under C0517 are
freely accessible.
•
Enter the required code numbers in the
subcodes.
Codes, which are only active when being
used together with an Application-I/O,
cannot be entered!
L