Ecolab Versatronic Manuel D'utilisation page 514

PC setup program
Battery
Here, the voltage of the backup battery and the board temperature of the device in Ecolab
PC Setup program is displayed.
Go to: On-line parameters è Verify / test è (double-click) Battery tab
Touch
In this view, the touchscreen may be calibrated through the calibration (see "touchscreen",
Ä Chapter 10.9 'Calibrating the touchscreen' on page 183 ) from the Ecolab of the PC
Setup program. In addition, the calibration of the touchscreen are presented in detail.
These are used to diagnose problems with the touch operation along with the Ecolab
service.
Go to: On-line parameters è Verify / test (double-click) è Touch tab
Display
Under this tab, four different test images can be enabled on the device display.
These are used for diagnostic display problems with the Ecolab service.
Go to: On-line parameters è Verify / test è (double-click) Display tab
Various process values
Select the process data to display in the online window. As well as the tabs with standard
selecting of process data, the online window features the tab "Selected process data".
After setting this process data is displayed.
The process data in the internal device memory can be displayed in real
time in the online window. See the Section on "On-line data",
12.9 'Online parameters' on page 236
A requirement for the real-time display of the process data is an existing
connection of Ecolab PC setup program with the device.
417102269 Rev. 2-08.2020 242
Ä Chapter