Ecolab Versatronic Manuel D'utilisation page 351

Commissioning
8.2.1 Checking option boards
In the Device Info / Slots menu, you can check the correct assembly of the device with
option boards. From here, the functionality of the device can be tested.
Device menu è Device info è Slots
Each correctly installed option board has a tab showing hardware and software
information.
Fig. 28: Example view: Hardware information for a "universal input" option board
If no tab appears for an option board, it was not recognised and there is a hardware
problem. In this case, check whether the option board in question has been installed
correctly. See Ä Chapter 11.1 'Installing option boards ' on page 184.
If that also fails, contact the technical support of Ecolab.
Ä Table on page 16
You can find the contact details here:
79 417102269 Rev. 2-08.2020