Drilling Plan - Ecolab Versatronic Manuel D'utilisation

Assembly
6.2.1

Drilling plan

Fig. 7: Drilling plan
Procedure
1. Draw the mounting holes on the mounting surface according to the drilling plan.
You can also use the mounting plate as a template.
Leave enough space in the area of the cable entries to manoeuvre the cables.
2. Mount suitable fastening screws (4) so that the screw heads are about 1 cm from the
mounting surface.
3. Fasten the mounting plate (2) with the screws (3) on the back of the device (1).
4. Hang the device (1) and, if necessary, the weather protection roof ( 5) into the
screws with the mounting plate.
5. Tighten the fastening screws.
417102269 Rev. 2-08.2020 46