Ecolab Versatronic Manuel D'utilisation page 353

9 Use
Personnel:
9.1 Use concept
This section explains how to use the functions at user level (e.g. controllers and data
monitors) and accessing the menu structure for making device settings. You use Ecolab
'Versatronic' via the touchscreen, tapping with your finger or a stylus with a soft, rounded
plastic tip.
CAUTION!
The touchscreen must not be operated with sharp or pointed objects, since
they can damage the protective film and the touchscreen.
To clean the touchscreen only use a soft cloth. Everyday cleaning agents
may contain substances that damage the protective film and display.
The operation depends on the user rights. General and settings options
vary depending on the rights of the user.
9.1.1 Passwords and user rights
There are three user levels in the device with factory-configured user names, passwords
and user rights. Passwords can be changed in the device.
The following tables provide an overview of the user accounts set up at the factory and
the corresponding passwords as well as the access rights of the respective user level.
Default passwords
User levels
Factory password
CAUTION!
The passwords shown here are only for the "initial configuration" of the
device!
To ensure process security, we urgently point out that passwords must be
changed and stored securely after successful configuration.
Default user rights
User rights
Display
Display overview, individual and controller images
Calibration / Show calibration log
Configuration / Show parameters
n Production supervisor
n Operator
Without
logon Operator
- 08662
81
Master Service
08662 (reserved for Ecolab)
User level
Without
Operator
logon
X X
X X
X X
417102269 Rev. 2-08.2020
Use
Master Service
X X
X X
X X