Ecolab Versatronic Manuel D'utilisation page 510

PC setup program
In the Ecolab PC Setup program the Ethernet settings are set in the online
parameters. From the PC, the IP configuration of the device can also be
changed if PC and device are connected via Ethernet. In this case,
changing the IP address or subnet mask can end the PC/device
connection.
See
12.9.4 Enable extra codes
This function is used to unlock the device software-based type addons (registration
function, mathematical and logical module) by the customer. When you get an addon for
the device software, you must create a code number using the PC Setup program.
This is required by Ecolab to generate a personal activation code, which you need as a
customer to unlock the desired device functions.
After calling the "Enable extra codes", you have three options:
n Generate code number
To purchase one additional type of device software, you need to create a device and
options-related code number and send them to Ecolab. Using this code number
Ecolab then gives you the activation code that allows you to unlock the desired option.
n Enter activation code
You receive this after you have sent the code number of the extra code of your device
to Ecolab, then use the unlock code for this option. After correctly entering the
activation code you can use the option in the device.
n Reset type additions
With this option, all software-based type addons may be disabled in your device.
Activating addons: On-line Parameters è Activation of extra codes (Double)
12.9.5 Delete internal data
When calling this function, the measurement data memory of the data monitoring and
recording function is completed and permanently deleted. The measurement data
recording is then set up again.
Delete internal data: Online parameters è Delete internal data (double-click)
12.9.6 Calibrate / test
CAUTION!
With "Calibrate / Test", the outputs adopt the defined states. "Verifying and
testing" must therefore not be called in a working plant, operated by Ecolab
'Versatronic' .
You can find numerous test functions under "Verify / Test", which appear in "Device menu"
in a similar way in the "functional level" or the "Device Info". The contents and functions of
each tab of the window "Verify / Test" are described in the following.
Hardware / software
Used to query version numbers of the device software and hardware information such as
the option board assignment.
417102269 Rev. 2-08.2020
Ä Chapter 12.7 'Connecting to the device' on page 200.
238