Dräger REGARD 3000 Mode D'emploi page 165

Errors and mes-
sages
N/A
Configuration
warning
Reduced data
rate
Missing exter-
nal switching
element
Wrong ext.
switching ele-
ment assign-
ment
Wrong ext.
switching ele-
ment input
mode
Missing ext.
overr. ack.
switching ele-
ment
Wrong ext.
overr. ack.
switching ele-
ment assign-
ment
|
Instructions for use
REGARD 3000
Cause
x x - Module communication
fault
- - - At least 2 identical
channel addresses
available in the system
- - - Data rate in the
REGARD 3000 network
is too low
x x - Comfail, interrupted or
no communication with
external switching ele-
ment (button or rotary
switch)
x x - Comfail, incorrect
assignment to external
switching element (but-
ton or rotary switch)
x x - Comfail, incorrect mode
of operation of external
switching element (but-
ton or rotary switch)
x x - Comfail, interrupted or
no communication with
external switching ele-
ment (button) for
acknowledging over
range
x x - Comfail, incorrect
assignment to external
switching element (but-
ton or rotary switch)
Fault elimination and messages
Remedy
Check system com-
pleteness in topology
view; replace module
that is not shown (com-
munication LED off)
Check and correct con-
figuration
Check and correct the
REGARD 3000 network
installation (at modules
and Ethernet ports, see
Ethernet port LED
table)
Check connection
between Docking Sta-
tions and affected mod-
ules and assignment of
modules to external
switching elements
(button or rotary switch)
Check and correct
assignment to external
switching element (but-
ton or rotary switch)
Check and correct
mode of operation of
external switching ele-
ment (button or rotary
switch)
Check connection
between Docking Sta-
tions and affected mod-
ules and assignment of
modules to external
switching elements
(button or rotary switch)
for acknowledging over
range
Check and correct
assignment to external
switching element (but-
ton) for acknowledging
over range
|
en
165