Icons In The Measured Value And Status Field Of The Channel Display With Modbus Output Channels; Display Prioritisation - Dräger REGARD 3000 Mode D'emploi

|
en
Control
6.15 Icons in the measured value and status field of the
channel display with Modbus output channels
Symbol
6.16

Display prioritisation

Prioritisation is automatic depending on the importance for the user.
The display of channel states in the system is prioritised as follows (list with
descending priority):
Symbol
▼
▼
▼
A
▼
▼
▼
If there is an alarm on the channel before the occurrence of an error, this state is
frozen during the error. Once the error has been rectified, the alarm condition is
displayed once again or updated where applicable.
132
Modbus
Description
Channel in Inhibit state
Channel in fault state
Input channel in alarm state
Output channel in alarm state
Communication error (Comfail) on the channel
Channel in warning state
Channel has information
Description
A Modbus communication is pending.
Instructions for use
|
REGARD 3000