Display Unit Settings; Configuration Role; General Configuration Procedure - Dräger REGARD 3000 Mode D'emploi

8.4.4

Display Unit settings

To display device information on the Display Unit:
1. Select
 The device information is displayed.
2. As necessary: Select export to save the information as a log file on a USB stick
connected to the Display Unit.
To adjust the screen:
1. Select
2. Make the desired settings:
Display test:
Display brightness:
8.5

Configuration role

After logging into the system the default view will be displayed (configurable). For
further information, see the following chapter: "Display Unit settings", page 162.
8.5.1

General configuration procedure

The general steps required to configure a Port are described below.
8.5.1.1 Open configuration mode
CAUTION
Danger of inconsistent configuration
All settings and system comparisons carried out in configuration mode always
relate to the system configuration imported when accessing configuration mode.
Subsequent changes of transmitter configurations are not taken into account.
► Do not make any changes to the connected transmitters during configuration
mode.
|
Instructions for use
REGARD 3000
> Information > Device information.
> Settings > Display and touch settings.
Testing the basic colours will display a red, green,
blue and black screen in succession. Takes approx.
20 s.
Set screen brightness.
|
en
User roles
147