Relay Module 4/8 Ch Port Configuration - Dräger REGARD 3000 Mode D'emploi

To remove a channel:
1. Select the check box of the channel. If necessary, enable multiple channels for
removal.
2. Select
8.5.4.10 Transmitter diagnostic parameter menu
If transmitter diagnostics is selected, the consistency between the transmitter
parameters (configurable) and the relevant parameter values set in the 4-20 mA
Input / HART module is checked. If deviations occur, a warning is displayed.
To suppress the diagnostics warnings:
1. Select the Suppress diagnostic warnings check box.
To select the transmitter parameters for which consistency is to be checked:
1. Select the check box of the desired transmitter parameters.
8.5.5

Relay Module 4/8 Ch port configuration

8.5.5.1 Channel parameter menu
For further information see: "Channel parameter menu", page 150.
8.5.5.2 Device parameter menu
In this menu information on the device that is switched by the relay can be
recorded.
Parameter
Device name
Device part num-
ber
Device serial num-
ber
8.5.5.3 Energize & Delay parameter menu
The behaviour of the relay can be set in this menu.
|
Instructions for use
REGARD 3000
to remove all selected channels from the list.
Description
Device name of the device connected to the relay.
Order number of the device.
Serial number of the device.
|
en
User roles
157