Channel View Of The Module Types - Dräger REGARD 3000 Mode D'emploi

|
en
Control
Symbol
6.12

Channel view of the module types

Symbol
130
Description
There is a communication error (Comfail) on the channel.
There is additional information on the channel as well as the dis-
played channel information.
The channel has multiple faults.
The channel is in a test or simulation mode.
The measured value of the channel exceeds the full scale value (over
range).
Signals the open input of a digital input channel.
Signals the closed input of a digital input channel.
The relay coil of the associated output channel is activated.
The relay coil of the associated output channel is not activated.
A delay time for activation of the channel is active on the channel.
A delay time for deactivation of the channel is active on the channel.
An acknowledgement can be implemented via or on this channel.
There is a complex configuration on the channel.
The channel has an alarm 1.
The channel has an alarm 8 and there are additional alarms on the
channel.
Description
4-20 mA Input Module / HART (input)
Relay Module (output)
Modbus Gateway Module (output)
|
Instructions for use
REGARD 3000