Dräger REGARD 3000 Mode D'emploi page 148

|
en
User roles
To open configuration mode:
1. Select
2. Select
 Enter configuration edit mode is displayed.
3. Follow the directions on the display.
 The current system configuration is loaded.
 The activated configuration mode is displayed by a dark-blue header.
8.5.1.2 Changing parameters
To change parameters:
1. Open configuration mode.
2. Select [Docking Station] > [Module] > [Port].
3. Changing parameters.
sections.
 Changes are marked by a colour bar.
with a
remedy.
4. Select
5. If necessary, configure additional Ports.
● To cancel all changes and to exit configuration mode:
Select and confirm
● To start the transfer wizard: Select
transfer wizard.
user to enter a control code generated by the system. By entering this code, the
user confirms the accuracy of the displayed system configuration.
All changed channels are locked during transfer of the configuration to prevent
unplanned malfunction of the system. The locked channels must be restored to
their standard operating mode after configuration.
Channels that depend on the changed channels are not locked.
8.5.1.3 Changing module names
A unique module name can be assigned to any module.
1. Open configuration mode.
2. In the system component view, select the Docking Station and the module.
3. In the module row, select the
 Information on the module is displayed.
4. Input the desired module name in the Module tag input field.
5. Transfer configuration.
148
.
.
The parameters of the various modules are explained in the following
In the event of implausible or invalid inputs, the relevant input field is marked
or . Selecting this symbol displays information on the cause and
to confirm the changes.
.
Before activating the amended system configuration, the system prompts the
> Send and follow the instructions of the
button.
Instructions for use
|
REGARD 3000