Assembly Instructions; Safety Testing - Louisiana Grills LG CHAMPION Assemblage Et Fonctionnement

In accordance with the procedures and specifications listed in UL SUBJECT 2728-2009 "PELLET
FUEL COOKING APPLIANCES" AND CANADIAN ULC/ORD C2728 and CSA C22.2 #3 "FOR
ELECTRICAL FEATURES OF FUEL BURNING EQUIPMENT. " The Champion pellet cooking
appliance has been independently tested and listed by INTERTEK (an accredited testing
laboratory) to ETL, UL, ULC and CSA standards.
This product has been assessed and meets EU (European Economic Area) safety, health and
Environmental protection requirements.
This product has been assessed and meets requirements imposed or covered by regulations
in Australia and New Zealand and is represented by RCM mark and number.
NOTE: Please read the label found attached to the inside lid of the hopper, carefully. It contains
important information about installation and operation of your pellet cooking appliance.
IMPORTANT NOTICE
• Be sure to inspect the entire grill after removing the protective shipping carton
• Report any damage to your local dealer immediately
• Shipping damage is not covered under warranty.
Phillips Screw Driver, Wrench, & Level
1 INSTALL THE WHEELS
Parts Required:
1 x Main Cabinet
2 x Wheels (5 in.) Locking Swivel Wheels
12.7cm
2 x Wheels (5 in.) Wheels
12.7cm
16 x Bolts (A)
16 x Washers (B)
16 x Spring Washers (C)
WARNING!
Due to the size and weight of the upper cooking cabinet,
the following installation step is a two (2) person job.
NOTE:
Damage caused due to ignoring warning or improper
installation is NOT a warranty issue.
8

SAFETY TESTING

TOOLS REQUIRED
ASSEMBLY INSTRUCTION