Louisiana Grills LG CHAMPION Assemblage Et Fonctionnement page 15

• Insert the screws through the two (2) holes provided in
front of the side shelf top, #23.
• Use a Phillips screwdriver to tighten to a snug, secure fit.
Step 3 Bottle Opener
• Remove the two (2) screws pre-installed in the shelf.
• Line up the two (2) holes on the bottle opener with the
two (2) holes provided on the side shelf top, hand
start the screws tighten using a screwdriver.
Step 4 Side Shelf to Cabinet
• Begin by hand starting each of the six (6) screws, spring
washers and washers, then using a Phillips screwdriver
tighten to a firm, secure fit.
14 INSTALL THE GREASE TRAY
Parts required:
3 x Grease Trays
3 x Face Plates
3 x Handles with screws
Installation:
• Remove the two (2) screws from each handle.
• Install the screws through the two (2) holes provided in
the front of the grease trays.
• Place one (1) of the face plates onto the two screws, then
line up the screws with the handle.
• Use a Phillips screwdriver to tighten to a snug, secure fit.
TIP: To aid in cleaning and reduce maintenance, line the grease
drawer with foil, or a thin layer of sand.
15 INSTALL THE SLIDER DAMPER
Parts required:
2 x Screw-in Damper rods with knobs
Installation:
• Slide each of the rods through the front panel of the
smoke cabinet.
• Insert the threaded ends into the two dampers found
inside the smoke cabinet.
• Turn clockwise until a firm fit is established.
15