Igniter - Louisiana Grills LG CHAMPION Assemblage Et Fonctionnement

Now with the hopper partially secured, hand start the remaining five (5) multi-heads screws, spring washers and washers. When
complete secure firmly into place, using the proper tool.
NOTE: Taking extra care not to strip the screw heads will aid in the future.
4 INSTALLING THE IGNITER ASSEMBLY
Parts Required:
2 x Phillips Metal Screws (H)
1 x Igniter Assembly (located in hopper)
Installation:
The Igniter assembly has been connected to the wire harness at the factory and
can be found in the hopper electrical housing.
• Reach in through the burn pot and carefully pull the igniter assembly forward
into the burn pot area. Diagram A
• Line up the two holes on the igniter bracket over top of the two holes found in
the bottom of the burn pot. Diagram A & B
• Using your screw driver and the two (2) Phillips metal screws (H) secure the
igniter assembly to the burn pot. Diagram A & B
5 INSTALLING THE BURN GRATE
Parts Required:
1 x Burn Grate
Installation:
• The larger lip of the grate, notched, installs
under the pellet fuel deflector.
• The bend along the larger lip should also be
sitting tight to the back of the burn pot (B).
• The front lip of the grate should be sitting
flush along the top of the burn pot (C).
IMPORTANT: The placement and maintenance of the burn grate is vital to a happy and full range cooking experience!
6 INSTALLING THE "ARCHED FLAME BROILER"
Parts Required:
1 x Flame Broiler Bottom
1 x Flame Broiler Slide Top
Installation:
• To ensure proper height and angle, the bottom plate of the
mounting bracket (A) should not be within the pellet drop
chute area. If you do need to adjust the bracket, loosen off
the three (3) Phillips screws, lift the bracket and re-tighten
the screws.
A
B
11