Mounting The Hopper To The Main Barrel; Securing The Igniter To The Burn Pot - Louisiana Grills LG Série Manuel D'installation Et Fonctionnement

4. MOUNTING THE HOPPER TO THE MAIN BARREL

Parts Required:
1 x Hopper Assembly (#5)
6 x Hopper Screw (#H)
Screw (#D)
2 x
Washer (#E)
8 x
8 x Locking Washer (#F)
Installation:
• Place the hopper on the ground next to the grill barrel, ready for
installation. On the exposed side of the hopper, locate the grill probe
wires taped to the outside of the hopper. Remove the tape, and let the
grill probe wires hang out of the hole. Note illustration 4A.
NOTE: Locate the igniter and tuck it completely into the opening at
the bottom of the hopper, as it will be installed on the next step.
• Lift the hopper off the ground, and with your foot resting on the
bottom shelf, carefully support/balance the hopper on your knee.
Firmly connect the silver grill probe temperature wires (on the main
barrel) to the wire spade connectors from the hopper. Once the wires
are connected, tuck all excess wire back into the hopper.
IMPORTANT: Ensure that all excess wire is tucked into the exit hole.
Do not place wires near the fan blades, auger tube, or the igniter.
• Carefully, lift the hopper, with the grill probe wires connected, and
insert the auger feed tube into the auger hole on the main barrel.
Raise the hopper slightly, and rest on the mounting ledge of the main
barrel. Note illustration 4B.
NOTE: If the auger holes do not line up, the hopper may need to be
gently pushed downward to clip the hopper into place.
• Secure the hopper assembly to the main barrel, from the inside of the
barrel, using six washers, locking washers and hopper screws.
NOTE: Take care not to over-tighten to avoid stripping the screws.
• Attach the hopper handle to the side of the hopper using two washers,
locking washers and screws. Note illustration 4C.

5. SECURING THE IGNITER TO THE BURN POT

Parts Required:
Igniter Screw (#G)
2 x
Installation:
• From the inside of the main barrel, reach through the burn pot into the
bottom of the hopper, and carefully pull the igniter forward into the
burn pot. Align the holes on the igniter bracket with the holes on the
bottom of the burn pot. Secure the igniter bracket using two screws.
IMPORTANT: The holes for the two screws need to be self-tapped,
as they are not pre-threaded. If needed, carefully use a drill to start,
then finish tightening with screwdriver by hand.
NOTE: Take care not to over-tighten to avoid stripping the screws.
4A
4B
GRILL PROBE SPADE
CONNECTORS
4C
5
GRILL
PROBE
HOLE
IGNITER
9