Installing The Side Shelf; Connecting To A Power Source - Louisiana Grills FOUNDERS Serie Mode D'emploi

11
12
13
13.Insert the mounting brackets of the side shelf(#20) into the
mounting holes on the side cap of the grill. The unit is now
completely assembled.

INSTALLING THE SIDE SHELF

PARTS REQUIRED:
1
10
INSTALLATION:
•
PLACING THE GREASE BUCKET
PARTS REQUIRED:
1
INSTALLATION:
•
11 •

CONNECTING TO A POWER SOURCE

STANDARD OUTLET
This unit requires 110-120 Volt, 60 Hz, 410 Watt. It must be a 3-prong grounded plug.
Ensure grounded end is not broken off. The control uses a 5 amp, 110-120 volt, fast-
blow fuse to protect the board from the igniter.
GFCI OUTLETS
This unit works on most GFCI outlets, with a recommended size of 15 amp service.
If the GFCI outlet is highly sensitive to power surges, it will likely trip during the
start-up phase of operation. During the start-up phase, the igniter draws 300-700
watts of electricity which can be too much power for a GFCI outlet to handle. Each
time the GFCI trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
ON THE ROAD
Disconnect the igniter from the main wiring harness. Use the manual start-up
procedure. The unit can operate using a 12 volt, 100 watt positive wave length
inverter plugged into your automobile outlet. To use the automatic igniter, it is
recommended to use a minimum of a 1000 watt positive wave length inverter.
IMPORTANT: DISCONNECT UNIT FROM POWER SOURCE WHEN NOT IN USE.
x Side Shelf (#10)
Insert the mounting brackets of the Side Shelf into the mounting holes on the
side cap of the Main Grill.
x Grease Bucket (#11)
Place the grease bucket on the spout hook on the bottom of the main barrel.
Ensure it is level to avoid grease spills.
The unit is now completely assembled.
www.louisiana-grills.com
7