Assembly Preparation - Louisiana Grills FOUNDERS Serie Mode D'emploi

ASSEMBLY PREPARATION

MAJOR CAUSES OF APPLIANCE FIRES ARE A RESULT OF POOR MAINTENANCE AND A FAILURE TO MAINTAIN
REQUIRED CLEARANCE TO COMBUSTIBLE MATERIALS. IT IS OF UTMOST IMPORTANCE THAT THIS PRODUCT BE
USED ONLY IN ACCORDANCE WITH THE FOLLOWING INSTRUCTIONS.
Parts are located throughout the shipping carton, including below the grill. Inspect the grill, parts, and hardware blister pack after removing from the
protective shipping carton. Discard all packaging materials from inside and outside of the grill before assembly, then review and inspect all parts by
referencing the parts list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not covered under warranty. Contact
Customer Care for parts.
IMPORTANT: TO EASE INSTALLATION, USING TWO PEOPLE IS HELPFUL (BUT NOT NECESSARY) WHEN ASSEMBLING THIS UNIT.
Tools required for assembly: screwdriver. Tool not included.
ASSEMBLY INSTRUCTIONS
IMPORTANT: IT IS ADVISED TO READ EACH STEP ENTIRELY BEFORE STARTING ASSEMBLY ON INSTRUCTIONS. DO
NOT TIGHTEN SCREWS COMPLETELY UNTIL ALL SCREWS FOR THAT STEP HAVE BEEN INSTALLED. HARDWARE
COMBINATION INVOLVING A LOCKING WASHER AND WASHER SHOULD BE INSTALLED WITH THE LOCKING
WASHER CLOSEST TO THE HEAD OF THE SCREW.
A
1
20
19
B
1
4-2
C
1
20
D
1
WWW.LOUISIANA-GRILLS.COM | CANADA (TOLL FREE): 1.877.942.2246
9
20
19
19
19
20
FITTING LEGS TO THE BARREL
PARTS REQUIRED:
1 x Main Barrel (#9)
2 x Support Leg A (#19)
2 x Support Leg B (#20)
12 x Screw (#A)
16 x Washer (#B)
16 x Locking Washer (#C)
4 x Screw (#D)
INSTALLATION:
• Place a piece of cardboard on the floor to prevent scratching the unit. Lay the
Main Barrel on its side, hopper end pointed upward, on the cardboard.
NOTE: FASTEN THE SCREWS OF THE SUPPORT LEGS ONLY HALF-WAY TO
ALLOW EASIER INSTALLATION OF BOTTOM SHELF IN NEXT STEP.
• Mount Support Leg A to the floor end of the Main Barrel using one Washer,
Locking Washer, and Screw (#D) from the inside of the main barrel. Note
illustration 1A.
• Next, from inside the Main Barrel skirt, install three Washers, Locking Washers,
and Screws (#A) into the same support leg. Repeat installation for Support
Leg B on the floor end of the Main Barrel. Note illustration 1B.
• Repeat the same installation for Support Leg A and B on the hopper end of the
Main Barrel. Note illustrations 1C and 1D.
www.louisiana-grills.com
3