Assembly Preparation; Assembly Instructions; Attaching The Spacer Bar; Installing The Mounting Bracket - Louisiana Grills LGCAB 61299 Mode D'emploi

Parts are located throughout the shipping carton, including in and under the appliance. Inspect the parts, and hardware blister
pack after removing from the protective shipping carton. Before assembly of product, review all parts and reference the parts
list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not covered under warranty. Contact your
dealer or Louisiana Grills Customer Service for parts.
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver, wrench and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed.

1. ATTACHING THE SPACER BAR

Parts Required:
1 x Smoke Cabinet (#9)
Spacer Bar (#4)
1 x
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit
and parts during assembly. Place the Smoke Cabinet upright in the
center of the cardboard, with the circular opening at the top.
• On the side panel near the bottom edge, remove the three
preassembled screws on the Smoke Cabinet. Attach the spacer bar and
secure using the same screws previously removed.
IMPORTANT: Do not tighten screws completely until the Smoke
Cabinet has been mounted to the grill and the chimney have been
installed.

2. INSTALLING THE MOUNTING BRACKET

Parts Required:
Mounting Bracket (#3)
1 x
Installation:
• On the same side as the spacer bar, near the top edge, remove the
six preassembled screws on the Smoke Cabinet. Attach the mounting
bracket and secure to the Smoke Cabinet using the same screws
previously removed.
IMPORTANT: Ensure the hook part of the bracket is at the top, as this
will be the part that mounts to the grill barrel.

ASSEMBLY PREPARATION

ASSEMBLY INSTRUCTIONS

1
2
5