Louisiana Grills LG CHAMPION Assemblage Et Fonctionnement page 12

• Take the Arched Flame Broiler bottom, and hold it so that the end with
the cut out and slots is in your left hand. The plate then clips easily
over the adjustable mounting bracket (B).
• Take the Arched Flame Broiler Slider Top, (D) and place it on top of the
bottom (C). This plate is used to slide over the flame broiler opening
and should be a very close fit.
OPEN for "Direct" flame searing / char broiling, Controlled flare ups
Remember this will affect the convection flow.
CLOSED for "Indirect Convection Cooking". Used in this position the
majority of time.
IMPORTANT: Both the flame broiler main body and slider top have a
food grade oil coating on them, when new. This will burn off during
the initial burn off.
7 INSTALLING THE MAIN LID HANDLE
Parts Required:
1 x Stainless Steel Handle with
2 x Phillips Screws
2 x Bezel - Decorative Washer
Installation:
• Using a Phillips screwdriver, remove the two (2) screws
from the main handle.
• Insert one screw, spring washer and washer, through
the hole provided in the barrel hood.
• Install the metal bezel on the screw end sticking
through the barrel.
• Hand thread and tighten this screw to one of the ends
of the stainless steel handle.
• Follow the same procedure to secure the other end of
the handle to the barrel lid.
• Firmly tighten both screws until handle feels firm.
CAUTION! DO NO OVER-TIGHTEN!
Only a snug fit is required.
8 INSTALL THE UPPER CABINET ADJUSTABLE CHIMNEY
Parts Required:
1 x Upper Cabinet
4 x Phillips screws (D), spring washers (F), washers (G)
1 x Gasket
1 x Adjustable Chimney Assembly
Base
Adjustable Damper
Chimney Cap
12