Louisiana Grills LG CHAMPION Assemblage Et Fonctionnement page 9

Installation:
The bottom portion of the main cabinet, has threaded plates installed to allow for two (2) locking and two (2) non-locking heavy
duty wheels to be installed.
• To ease installation, place a soft protective covering on the floor, then carefully tip the main cabinet with the non-hopper
end, onto the floor covering.
• Install the two (2) swivel locking wheels on the hopper end of the cabinet. Place a washer (B), then spring washer (C) onto
each bolt, then begin to hand tighten each bolt.
NOTE: It is best to start each threaded bolt by hand, to ensure the thread DOES NOT cross thread or strip.
• Install the two (2) non-swivel wheels to the smoker cabinet end.
• Using the proper tool, ensure that ALL bolts are firmly secured.
• Using one or two people carefully and slowly tip unit back onto the newly installed wheels.
2 INSTALL THE MAIN LID STOPPER
Parts Required:
1 x Main Lid Stopper
Installation:
• Using a Phillips Screwdriver remove the screw,
washer and spring washer already installed into the
top of the main barrel.
• Insert the main lid stopper into the slot provided in
the barrel.
• Line up the screw holes and re-install the Phillips screw,
washer and spring washer, through the stopper and
into the barrel.
3 INSTALLING THE HOPPER
Parts Required:
1 x Hopper Assembly
1 x Hopper Handle
2 x Phillips screws (D)
6 x Multi-head screws (E)
8 x Spring Washers (F)
8 x Washers (G)
Installation:
Step 1 - Installing the Hopper Handle:
The Hopper Handle is multi-purpose. Not only is used to move the unit,
but can also be used to wrap the power cord around, for easy storage.
The hopper handle also has two smaller size holes. These are used to
temporarily hold the meat probe.
9