Assembly Instructions; Disconnecting The Firebox And Cart; Expanding The Cart; Installing The Locking Caster Wheels - Louisiana Grills LG4BGGC1 Mode D'emploi

IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed, or unless otherwise mentioned.

1. DISCONNECTING THE FIREBOX AND CART

Parts Required:
Firebox (#3)
1 x
1 x Cart (#6)
Installation:
• Place a piece of cardboard on the floor and use the foam pieces to
prevent scratching the unit and parts during assembly.
• Unlock the four latches of the firebox from the cart. Using a second
person, lift the firebox away from the cart.

2. EXPANDING THE CART

Parts Required:
4 x Butterfly Screw (#A)
Installation:
• Unfold the cart by expanding the short-side support bars first, then
the long-side support bar. Secure the support bars of the cart by using
two butterfly screws, as shown in illustration 2A.
• Next, remove the cooking griddle from the cart and set aside.
• Finally, expand and secure the last long-side support bar using two
butterfly screws. Secure all support bars completely. Note illustration 2B.

3. INSTALLING THE LOCKING CASTER WHEELS

Parts Required:
4 x Locking Caster Wheel (#5)
Installation:
• Carefully, place the cart on its side to allow for wheel installation..
• Install the four locking caster wheels into each corner of the cart
bottom by rotating into the socket. Lock each caster.
• Once casters are installed and locked, turn the cart upright, casters on
the bottom.

ASSEMBLY INSTRUCTIONS

1
2A
2B
3
7