Connecting To A Gas Supply; Gas Cylinder Requirements; Connecting The Lp Gas Cylinder; Preparation For Use - Leak Testing - Louisiana Grills LG4BGGC1 Mode D'emploi

Barbecue de réception et plaque de cuisson
Masquer les pouces Voir aussi pour LG4BGGC1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GAS CYLINDER REQUIREMENTS

To operate, you will need a precision-filled standard G30/G31 grill LP gas cylinder with
external valve threads. Use standard flexible tube with length less than 1.5 m (59 in).
The tube shall be readily visible across its entire length for inspection after installation.
The maximum diameter and the maximum height of the cylinder is 300 mm (11.9 in) and
600 mm (23.6 in) as shown in illustration.
CAUTION: You must have the proper regulator which relevant standard
is EN16129 and bottle in order for the barbecue to operate safetly and
efficiently. Use of an incorrect or faulty regulator is dangerous and will
invalidate any warranty. It is important to inspect the full length of the
tube. If it is evident there is excessive abrasion or wear, or the tube is cut,
the tube must be replaced prior to the appliance being used.

CONNECTING THE LP GAS CYLINDER

1.
Before connecting, ensure there is no debris caught in the head of the LP tank, head of the regulator valve, or in the head of
the burner and burner ports.
2. Connect the tube line to tank by turning the knob clockwise until it stops. Make sure that the tube is not twisted in any way.
3. Place the LP gas cylinder into the cylinder hole. Ensure the hose connected to the cylinder does not touch any of the grill
surfaces that could get hot. Keep the LP gas cylinder in place during operation of the barbecue. Do not place a spare cylinder
in the cylinder enclosure at any time. Allow the the LP gas cylinder to be easily accessible (not blocked) at all times.
4. Make sure the tank valve is in OFF position. Use the tank bolt to secure the tank in a fixed position. Ensure the tank is
completely upright, as it is unsafe to operate the grill if the gas tank is not installed properly.
5. Ensure the regulator valve on the grill is completely closed by turning the knob clockwise to the OFF position.
6. Remove the protective caps from the regulator valve opening and the top of the gas cylinder. Save the caps.
7.
Insert the gas cylinder valve into the threaded opening of the regulator valve. Turn the cylinder clockwise until firm. Hand-
tighten only.
8. LP gas cylinder is now installed.
WARNING: Shut off the gas cylinder if you smell gas. Attempt to re-install gas cylinder to ensure that tube
is connected properly.
PREPARATION FOR USE – LEAK TESTING
A leak test is used to determine the integrity of a seal. Before using your gas grill, perform a leak test on the connection between
the regulator and the gas cylinder to reduce the risk of serious bodily injury or death from fire or explosion. A leak test should be
performed a minimum of once a season, as well as:
before lighting your grill for the first time,
every time the gas cylinder has been changed,
after travel, especially over rough or bumpy roads,
after a prolonged period of storage or non-use.
10

CONNECTING TO A GAS SUPPLY

MAXIMUM DIAMETER
300mm / 11.8 in
MAXIMUM
HEIGHT
600mm /
23.6 in

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

75010750117501227180919006228516849

Table des Matières