Installing The Cooking Components; Connecting To A Power Source - Louisiana Grills ESTATE Serie Assemblage Et Fonctionnement

5. INSTALLING THE COOKING COMPONENTS

Parts Required:
4 x Cooking Grids (#2)
1 x Upper Cooking Rack (#1)
1 x Flame Broiler Diffuser (#4)
Flame Broiler Slider (#3)
1 x
Installation:
• Insert the flame broiler main plate into the grill barrel. Rest the flame
broiler main plate on the built-in ledge (on the inside right) of the
main grill that directs grease towards the grease bucket. Slide the
entire piece to the left side, and the tray will lock into the raised tab
above the burn grate. Note illustration 5A. The flame broiler main
plate is used to distribute the heat evenly.
• Place the flame broiler slider on top of the flame broiler main plate, covering
the slotted openings. Ensure the raised tab is on the left, to easily adjust
for direct or indirect flame when cooking. Note illustration 5B. Both flame
broiler parts are lightly coated with oil to avoid rusting when shipped.
NOTE: When the flame broiler slider is open, and direct flame is used
while cooking, do not leave the grill unattended for any period of time.
• Place the cooking grids, side-by-side, on the grid ledge inside the
main barrel. Place the upper cooking rack on the upper ledge inside
the main barrel, locking into place, in the forward or receded position.
• The unit is now completely assembled.
IMPORTANT: To maintain the searing and grilling performance of
your cooking grids, regular care and maintenance is required. Wipe all
stainless steel surfaces – before use – to avoid any dirt, dust or oil from
cooking into the metal surface and causing discoloration during use.

6. CONNECTING TO A POWER SOURCE

• STANDARD OUTLET
This unit requires 110 volt, 60hz, 375w, 5 amp service. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off. The control uses
a 5 amp, 120 volt, fast-blow fuse to protect the board from the igniter.
• GFCI OUTLETS
This unit works on most GFCI outlets, with a recommended size of
15 amp service. If the GFCI outlet is highly sensitive to power surges,
it will likely trip during the start-up phase of operation. During the
start-up phase, the igniter draws 300-700 watts of electricity which
can be too much power for a GFCI outlet to handle. Each time the GFCI
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
IMPORTANT: Do not attempt to rewire the appliance directly to
a power source unless there is a separate breaker switch near the
appliance, clearly marked for emergency shut-off. Turn power OFF
when being serviced, or when appliance is not in use.
5A
5B
6
FAST-BLOW FUSE,
5 AMP
11