Positioning The Burn Grate; Installing The Cooking Components; Attaching The Lid Handle - Louisiana Grills 1900767 Mode D'emploi

6. POSITIONING THE BURN GRATE

Parts Required:
1 x Burn Grate (#7)
Installation:
• Proper placement and maintenance of the burn grate is vital to
the use of the unit. Insert the burn grate into the burn pot. The hole
in the burn grate should align and be open for the igniter to light
the pellets. To verify proper positioning, ensure the curved lip of the
burn grate is flush with the top of the burn pot, and the notched side
should sit flush, under the fuel deflector.

7. INSTALLING THE COOKING COMPONENTS

Parts Required:
3 x Cooking Grids (#2)
Upper Cooking Rack (#1)
1 x
Flame Broiler Main Plate (#4)
1 x
1 x Flame Broiler Slider (#3)
Installation:
NOTE: Both flame broiler parts are lightly coated with oil to avoid
rusting when shipped.
• Insert the flame broiler main plate into the grill barrel. Rest the flame
broiler main plate on the built-in ledge, right side first, of the main
grill that directs grease towards the grease bucket. Slide the entire
piece to the left side, and the tray will lock into the raised tab above
the burn grate. Note illustration 7A. The flame broiler main plate is
used to distribute the heat evenly.
• Place the flame broiler slider on top of the flame broiler main plate,
covering the slotted openings. Ensure the raised tab is on the left,
to easily adjust for direct or indirect flame when cooking. Note
illustration 7B.
NOTE: If the flame broiler main plate lays flat, on the base of the
barrel, it is installed incorrectly. The flame broiler should set at an
angle, with the left side sitting higher than the right.
• Place the cooking grids, side-by-side, on the grid ledge inside the
main barrel. Place the upper cooking rack on the upper ledge inside
the main barrel, locking into place, in the forward or receded position.
NOTE: To maintain the searing and grilling performance of your
cooking grids, regular care and maintenance is required.

8. ATTACHING THE LID HANDLE

Parts Required:
1 x Lid Handle (#11)
2 x Lid Handle Bezel (#12)
2 x Lid Handle Screw (#I)
Installation:
• From inside the barrel lid, insert one screw so that it protrudes to the outside.
Add a bezel on the screw, then hand-tighten the screw (from the inside) into
10
6
CURVED
LIP SITS
FLUSH
7A
TAB
7B
8
IGNITER