Mounting The Wheels To The Cart; Installing The Cart To The Barrel - Louisiana Grills 1900767 Mode D'emploi

2. MOUNTING THE WHEELS TO THE CART

Parts Required:
2 x Locking Caster Wheel (#13)
2 x Wheel (#14)
Wheel Axle Pin (#B)
2 x
Wheel Axle Washer (#A)
2 x
2 x Wheel Cotter Pin (#C)
Installation:
• Attach the wheel to the long support leg by inserting the wheel axle
pin through the wheel, long support leg, wheel axle washer, then secure
using the wheel cotter pin. Note illustration 2A. Repeat installation for
the other wheel.
• Insert each locking caster wheel into the bottom of each short support
leg by hand-tightening into the hole. Ensure the locking caster wheel
is inserted completely.
• Once all wheels are mounted, the two locking caster wheels should be
on the same side, and the two support legs with the wheels should be
on the opposing end. Note illustration 2B.

3. INSTALLING THE CART TO THE BARREL

Parts Required:
1 x Main Barrel (#8)
16 x Screw (#D)
Washer (#E)
16 x
Locking Washer (#F)
16 x
Installation:
• Lay the main barrel on its side, hopper end pointed upward, on the
cardboard. Ensure the support legs with the locking caster wheels are
pointed upward, on the same side as the hopper. Note illustration 3A.
• Insert the assembled cart into the main barrel brace, and secure each
leg to the brace using four washers, locking washers and screws. Repeat
same installation for the other three support legs. Note illustration 3B.
To ease installation of the final side, carefully turn the grill to lie on its
back to secure the last four screws to the main barrel brace.
• Once the cart is secured to the main barrel, position the grill back onto
its side (hopper end pointed upward), then carefully lift the grill up to
an upright position with the wheels on the bottom.
IMPORTANT: Lock caster wheels before lifting grill to upright position.
NOTE: If two persons are assembling the unit, the main barrel may
be lifted onto the upright cart to secure. Lift carefully to avoid injury.
8
2A
2B
3A
3B