Automatic Filling Using External Water Tank And Auxiliary Pump - SciCan STATCLAVE G4 Manuel De L'utilisateur

4.4

Automatic Filling Using External Water Tank and Auxiliary Pump

When connecting your STATCLAVE to an automatic filling system such as an external water tank and auxiliary pump, make
sure your unit is set to the AUTOMATIC filling mode. (See Section 4. Setting the water reservoir filling mode.)
An input hose can be connected to the STATCLAVE from
an external tank that uses an automatic water pump to feed
the internal tank automatically when it reaches the MIN level.
Be sure to monitor the water level of your external tank. The
STATCLAVE unit does not monitor the water level in the
external tank and the auxiliary water pump should not run dry.
To use this method, you will need the STATCLAVE automatic
fill pump (sold as an accessory) and an external tank with a
minimum diameter opening of 2" (50mm) through which you
can insert the pump.
To connect the automatic fill pump to the STATCLAVE,
follow these steps:
1. Remove the plug from the automatic fill port (A) at the
back of the unit.
2. Connect the fitting at the end of the pump's tubing to
the automatic fill port (A).
Connect the automatic fill pump's power source to the
3.
power connection (B) located at the back of the unit.
Fill the external tank (C) with distilled water.
4.
5. Place the submersible automatic fill pump (D) in the
external tank.
Go to the home screen and select any cycle to activate
6.
the filling system.
21