Manual Filling Using Reservoir Top - SciCan STATCLAVE G4 Manuel De L'utilisateur

4.1

Manual Filling Using Reservoir Top

1. With the unit powered ON, flip open the clean water
reservoir lid located on the top right of the unit.
2. Using a large container, fill with distilled water to the
maximum fill line or until you hear three BEEPs.
When adding water for the first time, the reservoir may
take up to 1 US gal / 4 L.
3. With the door open, select any cycle from the LCD's
home screen to view the pre-cycle information screen.
4. The clean water level check mark will turn yellow when
the minimum water level is reached and green when the
reservoir is filled to the maximum level.
You can start a cycle if water level icons are either yellow or green.
If your unit is not directly connected to the drain, empty the waste bottle regularly or each time you are filling the
clean water reservoir.
18