Using Your Statclave; Running A Cycle - SciCan STATCLAVE G4 Manuel De L'utilisateur

6.

Using Your STATCLAVE

6.1

Running a Cycle

Once the autoclave has been correctly installed and before using your STATCLAVE for the first time, make sure BOTH the clean
water reservoir and Venturi reservoir are full. Refer to Section 4. Filling the Water Reservoirs for detailed instructions.
1. Power on the unit
The main switch is located below the
door handle.
2. Ensure both reservoirs are full
You will not be able to start a cycle if the reservoir levels are
below the minimum fill lines.
3. Open the door
The LCD should display the UNLOCKED icon. Pull up
on the handle to disengage the manual latch and open
the door. If the door will not open, press the LOCK
icon to go to the door lock status screen and press the
UNLOCK icon.
CAUTION! Hot chamber.
The unit's Stand-by mode is preset to maintain a hot chamber.
To avoid burns, take care not to touch the chamber, rack or door with bare hands.
4. Load the instruments
Refer to Section 5. Loading Instruments for detailed
instructions
28