Automatic Filling Using A Vistapure Specialized Water Filtration System With Accumulation Tank - SciCan STATCLAVE G4 Manuel De L'utilisateur

4.3 Automatic Filling Using a VistaPure Specialized Water Filtration System
with Accumulation Tank
When connecting your STATCLAVE to an external filling device such as a VistaPure specialized water filtration system, make
sure your unit is set to the AUTOMATIC filling mode. (See Section 4. Setting the water reservoir filling mode.)
1. Remove the plug from the automatic fill port (A) at the
back of the unit.
Connect the water filtration system's Teflon tube (or
2.
other suitable tube) to the automatic fill port (A) at the
back of the unit.
3. Ensure the tube runs freely from the water filtration
system. It should not be sharply bent, crushed or
obstructed in any way.
4. Open the valve on the water filtration system (C) to
fill the accumulation tank.
5. Open the accumulation tank's (B) valve to facilitate the
flow of water to the STATCLAVE.
6. Go to the home screen and select any cycle to activate
the filling system.
IMPORTANT! Before you activate the AUTOMATIC filling mode, make sure the external tank has been filled with high
quality distilled water. Also remember to open the tap on the external tank or filtration system, if required.
IMPORTANT! When selecting an automatic filling option, it is best to use a direct-to-drain waste connection. Use of
an external waste bottle will require careful monitoring and frequent emptying.
High quality distilled water with a conductivity of 6.4 ppm / 10 µS/cm or less is recommended.
20