Filling The Water Reservoirs - SciCan STATCLAVE G4 Manuel De L'utilisateur

4.

Filling the Water Reservoirs

Normal operation of the STATCLAVE requires a minimum amount of distilled water in BOTH the clean water reservoir and
Venturi reservoir.
To fill the Venturi reservoir:
1. Open the Venturi reservoir lid located on the top left of
the unit.
2. Fill it with distilled water to the maximum fill line
indicated in the reservoir.
When filling the Venturi reservoir for the first time,
you will need to add an additional
0.5 US gal / 2 L of water. This will fill the steam cooling
system's condenser. To do this, simply fill the Venturi
reservoir to the maximum fill line and wait as the
Venturi reservoir water fills the condenser, then top up
the Venturi reservoir to the maximum fill line again.
Setting the water reservoir filling mode
Your STATCLAVE's default filling option is MANUAL. If you are manually filling the reservoir, you do not need to change the
unit's fill option settings.
If you are connecting your STATCLAVE to an external filling device such as a VistaPure specialized water filtration system or
external water tank and auxiliary pump, make sure your unit is set to the AUTOMATIC filling mode.
To change this setting from the home screen, select SETTINGS then USER and then follow these steps:
1.
To fill the clean water reservoir, there are four different methods:
›
Manual filling using RESERVOIR TOP.
›
Manual filling using the FRONT QUICK CONNECTOR.
›
Automatic filling using VISTAPURE SPECIALIZED WATER FILTRATION SYSTEM with accumulation tank.
›
Automatic filling using an EXTERNAL WATER TANK AND AUXILIARY PUMP.
2.
17