Getting Started - SciCan STATCLAVE G4 Manuel De L'utilisateur

3.

Getting Started

Preparing Your STATCLAVE for Use
Once the STATCLAVE has been correctly installed, and before using it for the first time, make sure BOTH the clean water and
Venturi reservoirs contain distilled water. The STATCLAVE uses water from the Venturi reservoir to generate vacuum draws at
the beginning and end of each cycle. Both reservoirs must contain the minimum required water levels for the unit to function.
IMPORTANT! DON'T run the STATCLAVE without the chamber rack in place.
1. Power on the unit.
2. Follow the screen prompts to connect your STATCLAVE
using either WiFi or an Ethernet cable connection. This
will automatically set the time and date for your unit.
If you do not wish to connect your STATCLAVE at this time, Press the FORWARD icon and select a language. Then
press the FORWARD icon and the SKIP icon to scroll to the end of the introduction. You must Agree or Disagree
with the Privacy Policy to get to the home screen. (For more information on the Privacy Policy screen see Section 8.
Using and Changing Settings.)
From the home screen, select the SETTINGS icon then the USER icon and then the GENERAL button to access
the menu for time, date, country, and time zone. (See Section 8 Using and Changing Settings)
(SciCan recommends connecting and registering your STATCLAVE. To do this at a later time, see Section 8.5
Registering for STATCLAVE Online Access.)
15