Important Information About Using Your Statclave - SciCan STATCLAVE G4 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.2

Important Information About Using Your STATCLAVE

Intended Use
The STATCLAVE G4 is a dynamic air removal (pre-vacuum) table-top steam sterilizer intended for use by a health care provider
to sterilize medical products by means of pressurized steam.
It is suitable for the sterilization of dental and medical instruments that are validated to be sterilized by steam. The STATCLAVE
G4 has not been designed to sterilize liquid loads, pharmaceutical products, bio-medical waste or materials not compatible
with steam sterilization. The processing of such loads may result in incomplete sterilization and / or damage to the autoclave.
For more information about instrument suitability for steam sterilization, consult the instrument manufacturers' reprocessing
instructions.
Get to Know Your STATCLAVE: Read this Manual
The details of installing, using and maintaining your STATCLAVE are all in this manual. Please read this manual before operating
the unit and keep it for future reference. Users should follow the operating instructions and maintenance schedule described
in this manual. Contents of this manual are subject to change without notice to reflect changes and improvements to the
STATCLAVE product.
Water Quality
High quality distilled water is recommended for use in your STATCLAVE. Deionized, demineralized, or specially filtered water
can also be used. Never use tap water.
User Qualifications
The operation and maintenance of this unit should be restricted to trained and authorized personnel.
Repair and Modifications
Do not permit any person other than certified personnel to supply parts, service or maintain your STATCLAVE. SciCan shall
not be liable for incidental, special or consequential damages caused by any maintenance or services performed on the
STATCLAVE by a third party, or for the use of equipment or parts manufactured by a third party, including lost profits, any
commercial loss, economic loss, or loss arising from personal injury.
Never remove unit panels. Never insert objects through holes or openings in the cabinetry (unless explicitly instructed as in the
emergency door opening procedure, for example). Doing so may damage the unit and / or pose a hazard to the operator.
WiFi Compliance
This device has been tested and found to comply with the limits for a Class B digital device pursuant to the Federal
Communications Commission's Part 15 Subpart B. The total radiated energy from the main antenna connected to the wireless
card conforms to the FCC limit of the SAR (Specific Absorption Rate) requirement regarding 47 CFR Part 2 Section 1093, when
the autoclave was tested. The transmission antenna for the wireless card is located in the front fascia.
CAUTION! Follow your local guidelines governing the verification of a sterilization procedure.
4

Publicité

Table des Matières
loading

Table des Matières