Using And Changing Settings - SciCan STATCLAVE G4 Manuel De L'utilisateur

8.

Using and Changing Settings

The STATCLAVE user menu provides you with access to settings that can be adjusted or changed. The chart below
offers an overview of where these settings can be found within the menu structure and tells you what you can do with each
button. Functions such as setting up load traceability, User IDs and PINs, setting drying times and Stand-by mode are
explained in more detail later in this chapter.
To access this menu from the home screen, select SETTINGS then USER. Use the UP and DOWN arrows to navigate
the menu. Press on a button to make a selection. Press the BACK button to move to a previous screen when navigating the
menus. After changing a setting, press the BACK button to save your selection.
USER SETUP BUTTONS
General
Language
Unit No.
Printer
Process
Screen
Network Setup
Sound
Instructions
SUBMENU BUTTONS
Time
Date
Set Time Zone
Time Update
Time 12/24
Date Format
Country
Units
Printer Type
Baud Rate
End of Line CR/LF
Printer user ° char
Enforced
User
Screensaver
LCD Contrast
Cycle Run
Network
Automatic IP (DHCP)
Renew IP
Button Beep
Beep Volume
Water Reservoir Filters
38
WHAT TO DO WITH IT
Enter values.
Enter values.
Select zone.
Select automatic or manual.
Select 12-hour or 24-hour format.
Select how date is displayed.
Type name to select country.
Select metric or imperial.
Select from language list.
For users with multiple units.
Select serial or no printer.
For printer adjustments.
For printer adjustments.
For printer adjustments.
Select ON, OFF or DOCUMENTATION.
Create User ID and PIN. Up to 20 users.
Adjust the time delay for the screensaver.
Adjust LCD readability.
Select circle or chart graphic to display
during a cycle.
Select WiFi or wired connection.
Network connection.
Network connection.
Turn the beep ON or OFF.
Adjust sound.
Slide show on how to clean the filters.