Connecting To A Printer; Adjusting Your Print Settings; External Printer Specifications - SciCan STATCLAVE G4 Manuel De L'utilisateur

9.4

Connecting to a Printer

Some users may prefer to have a printed record generated
after every cycle. To use an external printer you must connect
it to the STATCLAVE's RS232 port using the serial printer cable
supplied with your printer. Once the printer is connected,
enabled and its settings correctly adjusted (see below), it will
automatically print a record of each cycle.
To connect the printer, power on the printer and from the home screen, select SETTINGS then USER and follow these
steps:
1. Scroll to PRINTER and select
2. Select PRINTER TYPE.
Use the arrows to scroll to SERIAL PRINTER option
3.
and select. Press the BACK icon to save.
9.5

Adjusting your Print Settings

The STATCLAVE allows for several printer adjustments. To access these settings, select SETTINGS then USER and follow
these steps:
Select PRINTER.
1.
Use the arrows to scroll through the settings.
2.
Use the table below or your printer's operator manual to make
the correct adjustments to your printer's Baud Rate, End of
Line CR/LF and Printer User Char.
9.6

External Printer Specifications

Recommended Printer
Epson TM-U220D (C31C515603)
Under normal storage conditions, a thermal document will remain legible for a minimum of 5 years. Normal storage conditions
of thermal documents include avoiding direct sunlight, filing in office temperatures below 25 degrees Celsius and moderate
humidity (45% - 65% relative humidity) and not next to incompatible materials including plastic, vinyl, hand lotion, oil, grease,
alcohol-based products, carbonless paper and carbon paper.
End Of Line CR/LF
CR/LF
47
Serial Port Bitrate
9600
Printer user ° char
248 [0xF8]