SciCan STATCLAVE G4 Manuel De L'utilisateur page 41

Drying
Online
Water Filling
Stand-by
Custom Cycle
Solid/Unwrapped 132°C/4 min
Solid/Wrapped 132°C/4 min
Hollow/Unwrapped 132°C/4 min
Hollow/Wrapped 132°C/4 min
Textiles/Porous 132°C/4 min
Rubber & Plastic 121°C/20 min
Online Access
Privacy
Intro
Remote Access
Notifications
Auto / Manual
Stand-by On/Off
Stand-by Start
Stand-by End
Cycle temperature
Sterilization time
Drying time
39
Adjust drying time. (0 to 60 minutes)
Adjust drying time. (0 to 60 minutes)
Adjust drying time. (0 to 60 minutes)
Adjust drying time. (0 to 60 minutes)
Adjust drying time. (0 to 60 minutes)
Adjust drying time. (0 to 60 minutes)
Enter an email address to receive
notifications.
Agree: Your unit will send cycle data and unit
errors to SciCan. It will also receive automatic
software updates to the user interface.
Disagree: Your unit will NOT send any cycle
information but it will receive automatic
software updates to the user interface.
Select ON then use the power switch to
turn the unit OFF. The start-up screen and
connection wizard will begin when the unit is
next powered ON.
Use to generate a token that can be sent
to a technician who can access your unit
remotely.
Enter email addresses (max. 4) to which unit
can send notifications.
Select auto when using an external auto fill
system. Default is manual.
Select high, low or off. Default is high.
Enter time value. Default is 07:00.
Enter time value. Default is 20:00.
Select from 3 temperature options.
Adjust the custom cycle's sterilization hold
time.
Adjust the custom cycle's drying time.