SciCan STATCLAVE G4 Manuel De L'utilisateur page 31

5. Close the door
Close the door by locking the handle into position.
When you close the door, you will hear the sound of the
vacuum system adjusting chamber pressure to seal the
door. This is a normal operating sound.
6. Select the cycle
From the LCD, select the cycle you want to run. To
learn more about the available cycles, see Section 7.
Sterilization Cycles.
Press the icon to see the cycle name and parameters.
If User PIN ID has been enabled, you will be prompted to enter your User ID and PIN before your cycle selection is
accepted.
If there is a problem with the door lock or water, a PRECYCLE SCREEN will appear:
7. Press the START icon
If the chamber is cold, warming up can take up to 12
minutes.
Allow the cycle to run to completion.
IMPORTANT! When the drying stage is finished, the display will show the cycle is complete.
8. Cycle is complete.
When the cycle is complete, press the STOP icon to
release the load.
Clean water level low. Add water.
There is a water quality problem. Press icon to view detail.
Venturi water reservoir level low. Add water.
There is a problem locking the door. Check for instruments
jamming the door.
29