Manufacturer's Warranty; Spare Parts Lists - REMS Tornado 2000 Notice D'utilisation

eng
5.4. Fault: The dies are open too wide despite the right scale setting.
Cause:
● The die head is not closed.
5.5. Fault: Die head does not open.
Cause:
● Thread was cut to the next biggest pipe diameter with the die head open.
● Length stop folded away.
5.6. Fault: No useful thread.
Cause:
● Dies are blunt.
● Dies are inserted incorrectly.
● No or poor feeding of thread-cutting material.
● Poor thread-cutting material.
● Feed movement of the tool carrier obstructed.
● Pipe material is unsuitable for thread cutting.
5.7. Fault: Pipe slips in chuck.
Cause:
● Dies heavily soiled.
● Pipes have thick plastic coating.
● Dies worn.
6. Disposal
The thread cutting machines may not be thrown into the domestic waste at the
end of use. They must be disposed of properly by law.

7. Manufacturer's Warranty

The warranty period shall be 12 months from delivery of the new product to the
fi rst user. The date of delivery shall be documented by the submission of the
original purchase documents, which must include the date of purchase and the
designation of the product. All functional defects occurring within the warranty
period, which are clearly the consequence of defects in production or materials,
will be remedied free of charge. The remedy of defects shall not extend or
renew the warranty period for the product. Damage attributable to natural wear
and tear, incorrect treatment or misuse, failure to observe the operational
instructions, unsuitable operating materials, excessive demand, use for unau-
thorized purposes, interventions by the customer or a third party or other
reasons, for which REMS is not responsible, shall be excluded from the warranty
Services under the warranty may only be provided by customer service stations
authorized for this purpose by REMS. Complaints will only be accepted if the
product is returned to a customer service station authorized by REMS without
prior interference and in a fully assembled condition. Replaced products and
parts shall become the property of REMS.
20
Remedy:
● Close die head, see 3.1. Tools, changing the dies
Remedy:
● Close die head, see 3.1. Tools, changing the dies
● Set the length stop for closing and opening lever in the same direction.
Remedy:
● Change dies.
● Check numbering of dies to die holders, change dies if necessary.
● See 5.3.
● Use REMS thread-cutting materials.
● Loosen wing nut of tool carrier. Empty chip tray.
● Only use approved pipes.
Remedy:
● Clean dies.
● Use special dies.
● Change dies.
The user shall be responsible for the cost of shipping and returning the product.
A list of the REMS-authorized customer service stations is available on the
Internet under www.rems.de. For countries which are not listed, the product
must be sent to the SERVICE-CENTER, Neue Rommelshauser Strasse 4,
71332 Waiblingen, Deutschland. The legal rights of the user, in particular the
right to make claims against the seller in case of defects as well as claims due
to wilful violation of obligations and claims under the product liability law are
not restricted by this warranty.
This warranty is subject to German law with the exclusion of the confl ict of laws
rules of German International Private Law as well as with the exclusion of the
United Nations Convention on Contracts for the International Sales of Goods
(CISG). Warrantor of this world-wide valid manufacturer's warranty is REMS
GmbH & Co KG, Stuttgarter Str. 83, 71332 Waiblingen, Deutschland.

8. Spare parts lists

For spare parts lists, see www.rems.de → Downloads → Parts lists.
eng