Footswitch And Footpedal Connections • Headphones - Lexicon Vortex Mode D'emploi

Footswitch and Footpedal
Connections
Footswitches connected via the rear-
panel footswitch jacks allow you to perform
register STEP and BYPASS functions and/
or to control TAP and A/B effect morphing.
Two momentary foot-switches can be wired
to a tip-ring-sleeve connector. A stereo Y-
connector allows two identical single
switches to be used.
Tip Sleeve
TIP
RING
SLEEVE
STEP
Ring
Tip Sleeve
TIP
RING
SLEEVE
A/B
Ring
An expression pedal connected via the
rear panel pedal jack allows continuous con-
trol of selected front panel parameter.
Tip Sleeve
TIP
RING
SLEEVE
Ring
English
One footswitch is provided with your unit,
along with a set of labels to identify footswitch
functionality. If you are only going to be using
one footswitch,connect it to perform TAP and
A/B functions, or register STEP and BYPASS
functions, and label it accordingly.
BYPASS
A/B TAP
TAP
Use a second (optional) footswitch to control
the remaining footswitch functions.
Typical Pot(entiometer)
10-50K
PEDAL Sleeve Tip Ring
Headphones
A stereo signal which is adequate to drive
high-efficiency headphones is available at
the left output, provided no connections are
made through the right output . This feature is
provided as a convenience for practice pur-
poses, and is intended to provide only mod-
est volume.
STEP BYPASS
5