Lexicon Vortex Mode D'emploi page 26

Processeur d'”audiomorphisme” — ou transmutation audio
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Registers 4, 9, 10 and 14 have been cleared...
1
2
3
4
5
With the REGISTER/PRESET knob set to Register 1, the footswitch will
step through the remaining registers, then loop back to Register 1.
1
2
3
Turning the REGISTER/PRESET knob to any position other than 1,
will set up register chains which use cleared registers as loop points.
The combination of cleared registers shown above would
1
2
3
If the REGISTER/PRESET knob is set to a register within a chain, the
footswitch will cycle through the chain until the next cleared
register, then loop back to the first register in the chain.
(To use a chain containing Register 1, you must set the
REGISTER/PRESET knob to another register in the chain.)
With the REGISTER/PRESET knob
set to Register 7, the footswitch
will step through this sequence ...
If the REGISTER/PRESET knob is set to a cleared register, the footswitch will
skip to the first register in the next chain, then step through that chain.
English
6
7
8
9 10
11 12 13
5
6
7
8 11 12 13 15 16
create these four chains ...
5
6
7
8
11 12 13
7
8
5
Bypass
A footswitch can be used to toggle a by-
pass function. When active, "bP" (byPass)
14
15 16
appears on the display. In this state the
output of Vortex will remain at the level set by
OUTPUT, but will be 100% dry (MIX set-
ting=1).
While bypassed, PARAMETER, VALUE,
and any assigned pedal functions are inac-
tive.
REGISTER/PRESET and A/B functions
(via footswitch or front panel) remain active
during bypass, allowing you to cue an effect
to load when bypass is turned off.
15 16
To use this feature, turn bypass on ("bP"
displayed). Select a new effect (the ID num-
ber of the effect you select will briefly inter-
rupt the display of "bP". If you want to switch
banks, press A/B — the LED will respond to
your selection, although the relay will not be
activated until bypass is turned off. Now,
6
when you turn bypass off, the effect you've
selected will load.
TAP functions (via footswitch or front
panel) also remain active during bypass,
allowing you to change tempo while by-
passed.
23

Publicité

Table des Matières
loading

Table des Matières