Lexicon Vortex Mode D'emploi page 56

Mod Fx Lvl
ECHO 1
Fbk 1
Fbk 2
Fbk 2
Fbk 1
ECHO 2
Mod Fx Lvl
* ENVELOPE Increases filter modulation
ECHO FX LVL Delayed filter output level
MOD FX LVL Undelayed filter output level
FEEDBACK 1 Total gain of feedback mix for both delays
FEEDBACK 2 Feedback/cross-feed mix
RATE 1 Filter glide rate
DEPTH 1 Filter glide depth
RESONANCE 1 Left filter cutoff frequency
RATE 2 Rate of RATE 1 FM
DEPTH 2 Depth of RATE 1 FM
RESONANCE 2 Right filter cutoff frequency
English
Echo STEREO
Fx Lvl
FILTER
Rate 1*, Rate 2
Depth 1, Depth 2
Res 1, Res 2
53
Cycloid B varies the configuration used in Cycloid A by
placing the cross-mix echoes in front of the stereo filter. This
allows the filter to change the tone of echoes as they repeat.
ENVELOPE increases RATE 1 (filter modulation), so that you can
set the filter to behave in a specific way when there is input, and
another way when the signal is absent and there are only repeating
echoes. All other controls are as described in Cycloid A.
The Preset uses dynamic control of the filter modulation rate to
cause filter panning to increase with loud signals. When no input
signal is present, echoes still flow through the filter, but at a slower
panning rate. Settings of ECHO 1and 2, and FEEDBACK 1 and 2,
control these bouncing echoes. Use FEEDBACK 1 to increase or
decrease the total amount of feedback.
B
14 CYCLOID