Using Registers - Lexicon Vortex Mode D'emploi

Processeur d'”audiomorphisme” — ou transmutation audio
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Storing Effects
Vortex presets cannot be erased or over-
written by parameter changes; the original
version will always be restored when loaded.
If you make changes to a preset and want to
save the changes as a custom effect, or if
you want to match certain effects as A/B
pairs, you must store your new versions into
registers.
When first shipped, Vortex has a dupli-
cate set of the presets loaded into the regis-
ters. Although these are grouped into regis-
ter pairs which match the preset A/B pairs,
you can store any effect you want into any
register space. For example, you can store a
version of Centrifuge B into Register 1A, and
a version of Orbits A into Register 1B.
English
To store the currently running effect:
1. Press STORE.
2. If you were in preset mode, the register
LED will go on, indicating that Vortex has
automatically switched to register mode
— selecting whatever register is indi-
cated by the position of the REGISTER/
PRESET knob and the A/B button.
3. Releasing STORE will store the currently
running effect into the register indicated
on the display, overwriting the effect pre-
viously stored there. The display will flash
briefly to indicate the store operation was
successful.
21

Using Registers

4. Store operations are executed on re-
lease of the STORE button. If you want to
store to a different register, or to a differ-
ent register bank, than the one displayed,
turn the REGISTER/PRESET knob to the
register number you want, and check the
setting of the A/B button before releasing
STORE.

Publicité

Table des Matières
loading

Table des Matières