Audio Connections; Headphones; Footswitches - Lexicon JAMMAN Mode D'emploi

Audio Connections

Audio connections to JamMan are unbal-
anced and should be made with high quality
shielded cables with 1/4" tip-sleeve phone
jacks at the JamMan end.
JamMan produces effects from either
mono or stereo sources. With mono sources,
the dry signal appears, along with audio ef-
fects, at both outputs. For instruments and
sources with stereo outputs, use both inputs.
We recommend using the outputs in stereo
whenever stereo inputs are used, but if mono
output is required, use the right output jack.
The left and right signals are summed inter-
nally when only the right output is used.
English

Headphones

A stereo signal which is adequate to drive
headphones is available at the left output
(provided no connections are made through
the right output). This feature is provided as
a convenience for practice purposes, and is
intended to provide only modest volume.
One footswitch is provided with your unit, along with a set of labels to identify
footswitch functionality. If you are only going to be using one
footswitch,connect it to perform TAP and RESET/BYPASS functions, and
label it accordingly.
RESET/BYPASS TAP
FUNCTION SELECT
5

Footswitches

Footswitches connected via the rear-
panel footswitch jacks allow control of TAP
and RESET/BYPASS (or SELECT and
FUNCTION). Two momentary foot-switches
can be wired to a tip-ring-sleeve connector.
A stereo Y-connector allows two identical
single switches to be used.
Use a second (optional) footswitch to
control SELECT and FUNCTION.