Setting Audio Levels - Lexicon JAMMAN Mode D'emploi

Setting Audio Levels

1. Turn the Mode knob to ECHO .
2. Turn INPUT and OUTPUT all the way
down (fully counter-clockwise).
3. Set the instrument output or effects send
being input to JamMan to a nominal level.
With an instrument, this should be your
loudest playing level; with a console, ad-
just the output or effects send to produce
the highest level possible with the least
amount of noise.
4. While sending audio to JamMan, gradu-
ally turn up the INPUT control until the
status LED* lights green. Continue to
advance INPUT until the LED shows red
on only the loudest peaks. If the LED
shows red continuously, turn the INPUT
control down.
English
5. If JamMan is using a console's sends and
returns, set the MIX control fully clock-
wise (100% wet). If you are using an
instrument amplifier, start with MIX set
halfway up.
6. Gradually increase the setting of the
OUTPUT control until the audio level
from the amplifier or mixer is approxi-
mately the same as when JamMan is
bypassed.
* The status LED is off when the incoming signal is
low (more than 30dB below overload). Green
indicates acceptable levels (6 dB to 30dB below
overload). The LED lights red when the signal
approaches overload. Acceptable signals will
cause the LED to light green almost continuously,
with flashes of red on peaks.
3